<address id="913f9"></address>

      <noframes id="913f9"><form id="913f9"><th id="913f9"></th></form>

      <address id="913f9"><address id="913f9"><nobr id="913f9"></nobr></address></address>
      <address id="913f9"><form id="913f9"><nobr id="913f9"></nobr></form></address>

      <address id="913f9"><dfn id="913f9"><listing id="913f9"></listing></dfn></address>
        <address id="913f9"><listing id="913f9"><meter id="913f9"></meter></listing></address>
        <noframes id="913f9"><form id="913f9"><nobr id="913f9"></nobr></form>

        <address id="913f9"></address>

        全國咨詢熱線

        400-879-1999

        點擊撥打服務熱線:400-879-1999
        你所在位置: 首頁 >> 新聞中心 > 常見問題

        常見問題

        自動上料攪拌車驅動裝置的維護方法

        作者:http://www.www.boy7up.cn 時間:2023-01-13

        大家知道自動上料攪拌車的驅動裝置么?它的作用是驅動混凝土貯罐轉動,如果驅動裝置出現故障,那整個混凝土貯罐將不能轉動,這會導致車內混凝土報廢,嚴重的甚至導致整罐混凝土凝結在罐內,造成車報廢。所以我們應該做好它的維護工作。
        Do you know the driving device of the automatic feeding mixer? Its function is to drive the concrete storage tank to rotate. If the drive device fails, the entire concrete storage tank will not rotate, which will lead to the scrapping of the concrete in the vehicle, or even the whole tank of concrete will be condensed in the tank, resulting in the scrapping of the vehicle. So we should do a good job in its maintenance.
        1、保證液壓油清潔。自動上料攪拌車工作環境惡劣,一定要防止污水泥沙進入液壓系統。液壓油要按使用手冊要求定期更換。一旦檢查時發現液壓油中混入水或泥沙,就要立即停機清洗液壓系統、更換液壓油。
        1. Ensure that the hydraulic oil is clean. The working environment of the automatic loading mixer truck is harsh, so it is necessary to prevent dirty cement sand from entering the hydraulic system. The hydraulic oil shall be replaced regularly according to the requirements of the user manual. Once the hydraulic oil is found to be mixed with water or sediment during the inspection, immediately stop the machine to clean the hydraulic system and replace the hydraulic oil.
        自動上料攪拌車
        2、萬向轉動部分是故障多發部位,應按時加注潤滑脂,并經常檢查磨損情況,及時修理更換。車隊應有備用的萬向軸總成,以保證一旦發生故障能在幾十分鐘內恢復工作。
        2. The universal rotating part is the part with frequent faults. It should be filled with lubricating grease on time, and the wear should be checked frequently, and repaired and replaced in time. The team should have a spare cardan shaft assembly to ensure that it can resume work in dozens of minutes in case of failure.
        3、保證液壓油冷卻裝置有效。要定時清理液壓油散熱器,避免散熱器被水泥堵塞,檢查散熱器電動風扇運轉是否正常,防止液壓油溫度超標。液壓部分只要保證液壓油清潔,一般故障不多;但生產廠家不同,使用壽命則不一樣。
        3. Ensure that the hydraulic oil cooling device is effective. The hydraulic oil radiator shall be cleaned regularly to prevent the radiator from being blocked by cement. Check whether the electric fan of the radiator operates normally to prevent the hydraulic oil temperature from exceeding the standard. As long as the hydraulic oil of the hydraulic part is clean, there are few general faults; However, different manufacturers have different service life.
        以上就是自動上料攪拌車驅動裝置的維護方法,希望大家能夠定期維護,提高工作效率,延長它的壽命。更多使用事項就來我們網站http://www.www.boy7up.cn進行咨詢吧!
        The above is the maintenance method of the driving device of the automatic feeding mixer. I hope you can maintain it regularly, improve the working efficiency and extend its service life. Come to our website for more usage matters http://www.www.boy7up.cn Consult!
        新聞中心
        聯系我們
        • 公司:萊州聚峰機械有限公司
        • 熱線:400-879-1999
        • 地址:山東省萊州市206國道與308省道交叉口東南50米

        截屏,微信識別二維碼

        国语对白在线视频